Watch TurnTenFeed roughing big 4140 alloy forgings

Detailed Specification

Watch this very impressive footage of TurnTenFeed from @Tungaloy UK roughing big 4140 alloy forgings on a 1936 72″ King Vertical Lathe!!!

Application by Chris Moore, Owner and machinist at Steward Machine Shop Ltd.

Visit https://www.instagram.com/p/B3Cbtq3JpfJ/?igshid=1ft018bj6yzq8 for the full videos and commentary of his impressive work.

Chris says….

“These tools can rip off excess material like a beast!! They seem to like a high surface speed, and a high feedrate/rev. The corner and edge geometry of this tool are incredibly tough and bust through forging scale no problem.

I show a little bit of the one piece that is almost finished towards the end of the videos. I finished the surfaces with my go to Tungaloy SNMG-644TH T9125 for the OD and ID, and finish faced off the end with a Tungaloy DNMG-433TH T9125 to avoid the loose chips from scratching the surface at the low rpm the King runs at”

Contact Tungaloy UK for more details on this fantastic products.

☎️ 0121 400 0231

📧 salesinfo@tungaloyuk.co.uk

Tungaloy's Products

Latest from Tungaloy

Subscribe to the MTDCNC Newsletter